The SMOK Alien 220W Starter Kit is one of the most futuristic, sophisticated vaping systems on the market today. Equipped with high output capabilities, plenty of options and a uniquely impressive tank design, this kit satisfies on every level.
If you've just purchased this robust setup, you're in luck. We're here to make sure that you use this kit properly in order to experience the most vaping satisfaction possible.
Step #1: Remove the SMOK Alien 220W Mod from the box. You'll find a hinged battery door on the base of the mod. Open the battery door and insert two fully charged 18650 batteries.
Step #2: Take the tank out of the box. Locate the hinged door at the top of the tank. Open this door and fill the tank with three milliliters of your favorite sub-ohm vape juice.
Step #3: Inside the TFV8 Baby Beast Tank, you'll find a pre-installed V8 Baby-Q2 Coil. If this is the coil that you wish to use for your vaping session, leave it in the tank and prime it thoroughly. To do this, saturate the wick of the coil with vape juice and allow it to sit for a couple of minutes.
If you wish, you can take out this coil and replace it with the V8 Baby-T8 Coil that's inside the box in which your starter kit came. If you wish to use this coil, make sure that you prime it properly before using your device.
Step #4: Close the lid of your tank. Now, screw it onto the mod until it's tight.
Step #5: Turn on your device by pressing the power button the required number of times. The display screen on the mod's chassis should light up.
Step #6: Use the display screen and the navigation buttons to select your settings. This device can reach 220 watts. It also comes with various output and temperature control modes that you can feel free to explore.
Final Step #7: Fire your device and enjoy an exquisite vaping session!
The SMOK Alien 220W Starter Kit is an exceptional vaping system that comes with loads of options. By following this easy guide, you'll be enjoying its many features in no time.