The Eleaf iStick Pico S 100W is one of the most coveted sub-ohm systems out there thanks to its robust construction, its generous number of features and its reliable technology.  If you’re looking for a new DL setup to handle your most demanding needs, this is the kit for you.  But, before you start pouring in that vape juice and inserting those batteries, read this guide first.  We’re going to take you through the process of setting this kit up and using it for the first time so that you can get the most satisfaction imaginable right off the bat.

Step #1: Find two 18650 batteries that can be inserted into the Mod.  Make sure that the batteries are completely charged.  To insert the batteries, locate the battery door that’s on the base of the mod.

Step #2: Now, take the ELLO VATE Sub-Ohm Tank that comes with this kit.  This tank can hold 6.5mL of e-liquid when you utilize the convex glass piece that comes in the box.  Pour your vape juice into the tank, being careful not to exceed the maximum capacity line.

Step #3: Comes with two different coils.  Each coil corresponds with a different wattage level range.  Decide which coil you’d like to use.

Step #4: Now, it’s time to prime your coil.  Do this by saturating the exposed cotton sections in e-liquid.  Allow the coil to sit for about five minutes so that the e-liquid gets deep into the coil’s cotton wick.  Then, insert the coil into your tank by screwing it into the center.

Step #5: Install the tank into the mod until it’s secure.

Step #6: Turn on the mod using the power button.  The OLED display screen should light up at once.  Now, select your settings.

Final Step: Use the firing button to fire your first hit!

The Eleaf iStick Pico S 100W is a powerful and reliable vaping kit for sub-ohm lovers who want lots of power.  By following this guide, you’ll be well on your way to making the most of each and every puff.